Hummina Shadeeba
1 MW
how do you think it will go?! I will stack them and 6 long 12s. 4p. I can add more copper foil and plan to but now it's at a single thick .5mm with the dimples pressed in on an abs printed press. i'll go thinner on top since info on ES says it contours better for better connection.
how to get compression with them I like this tape most. If you wrap it on your finger with 5 turns pulling it on at a pretty light pressure, you will feel like you are going to explode and that's the testing so far. or maybe could use rubber bands and that was the original plan.
to be more scientific it'd be nice to figure how much pressure is put on the cells and how it decreases through use. if you have an idea? Maybe grin pressure sensors?
its super minimalist.
I'll add some balance lines from the exposed connection.
how to get compression with them I like this tape most. If you wrap it on your finger with 5 turns pulling it on at a pretty light pressure, you will feel like you are going to explode and that's the testing so far. or maybe could use rubber bands and that was the original plan.
to be more scientific it'd be nice to figure how much pressure is put on the cells and how it decreases through use. if you have an idea? Maybe grin pressure sensors?
its super minimalist.
I'll add some balance lines from the exposed connection.