96v charger.

Ok guys. I have this generic charger. It was meant to output the voltage labeled on the picture I have attached but actually only outputs 58v. Is there anything I can change on this board assembly to make it supply the voltageim after. I also have a blown 96v charger that I can use any components off that to assist. Any help would be much appreciated
Regards
Heath

The generic answer is maybe, maybe not.

A picture or at least link to the specific charger would help us give a specific answer. Some chargers have a pot that allows adjusting the voltage, but maybe not that far.

And, I'm moving this thread to the battery section.

It won’t ley me attach files. I attach then submit and nothing comes up?

This is the closest link I have. I have pictures of the charger with the cover off but cannot upload
http://www.cloudelectric.com/product-p/bc-f9607-220vac.htm

that is a generic aliexpress charger.
all the caps in the output stage need to be upgraded as some resistors that allow the pots to have the voltage range changed.
might be cheaper or at least simpler to just get a second charger and dial the voltage down and put them in series in order to get the 96v needed.