Hi
So I've checked for a signal from my throttle at the controller. It's a crystalite pedal first controller. Anyways I have 5-volts on the red and nothing on the green. Is it safe to say I need a new throttle? I checked continuity on every wire in the throttle as close to the throttle a possible and coming from the controller all good.
Thanks for any comments.
Throttle check
2 posts
• Page 1 of 1
Throttle check
by Crusher » Sat May 05, 2012 10:00 pm
Crytalyte 408, 48 volt Nicad 8 ah pedal first. For my 20 km each way commute. Not very badass but it works for me.
- Crusher
- 1 mW
- Posts: 11
- Joined: Thu Aug 28, 2008 1:58 am
- Location: Lower Mainland, British Columbia
Re: Throttle check
by Crusher » Fri May 11, 2012 3:35 pm
Nice little link to help noobs like me with basic troubleshooting saved me a couple of trips to Vancouver to get a pro to look at it. Ended up being my throttle. My bike took a hard fall and I think it landed on the throttle side of the handle bars.
oh yah heres the link. http://www.ebike.ca/troubleshooting.shtml
oh yah heres the link. http://www.ebike.ca/troubleshooting.shtml
Crytalyte 408, 48 volt Nicad 8 ah pedal first. For my 20 km each way commute. Not very badass but it works for me.
- Crusher
- 1 mW
- Posts: 11
- Joined: Thu Aug 28, 2008 1:58 am
- Location: Lower Mainland, British Columbia
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 16 guests