Hey Guys,
Is it possible to control the shunt resistance with a pot?
I want to add a pot across the shunt (not replace it) to add conductivity.
Will it work? and if so, what pot rating do I need?
I want to raise a 45A controller to about 100A and be able to bring it back to 45A (did it before with solder to well over 100A (I'm experimenting with a few different cooling techniques)).
Is it possible to control the shunt resistance with a pot?
I want to add a pot across the shunt (not replace it) to add conductivity.
Will it work? and if so, what pot rating do I need?
I want to raise a 45A controller to about 100A and be able to bring it back to 45A (did it before with solder to well over 100A (I'm experimenting with a few different cooling techniques)).