Hello,
I have ordered Enertion 4.12 Vesc from the last batch. Now I'm trying to set up it, and run motor detection.
Firstly, I connected vesc over the usb port and then powered it with 12V PSU. But only blue led is on. I have tried different usb cables even swopped pc's with different OS, tried to power it with 36V, but the same problem occurs. Maybe you have any suggestions? I guess that Vesc is missing BL/firmware
There is the video (not mine, but the same problem):
https://www.youtube.com/watch?v=nenIvSAVTyA
I have ordered Enertion 4.12 Vesc from the last batch. Now I'm trying to set up it, and run motor detection.
Firstly, I connected vesc over the usb port and then powered it with 12V PSU. But only blue led is on. I have tried different usb cables even swopped pc's with different OS, tried to power it with 36V, but the same problem occurs. Maybe you have any suggestions? I guess that Vesc is missing BL/firmware
There is the video (not mine, but the same problem):
https://www.youtube.com/watch?v=nenIvSAVTyA