methods
1 GW
I would like to collaborate around this device.
Here is what I have so far:
* Post 2015 the unit was available in IP65
* Units come pre-programmed with basic settings from Sevcon - some assembly required.
* DVT/Helper/CAN/Display Settings can be used to view and modify settings (be sure to set your node address correctly)
* If you know your index and sub index virtually any setting in the controller DCF can be modified.
Things I have yet to confirm:
* The unit can take a controller in and out of PreOp
* The unit requires Sevcon support to change the logo and splash screen
* The DCF can be saved off and manually modified (did this save yesterday, took forever, today I will poke around in it)
* Modified profiles (DCF) can be loaded back into the unit
* Unit is highly programmable in terms of CANopen behavior.
* Unit can be tailored to match customer standard setup... by hiding unneeded values... and exposing others. This will take many hours to get right, but once done, should be as quick as any other DCF flash.
* ThunderStruck-EV has posted quick start and programming manuals. These manuals are enough... but forget to tell you the tip above about accessing via DVT.
* There are 4 levels of programming access that can be applied via a hexadecimal code. These levels affect what your customer can and can not change. These expose things like Back Door and Personalities. THIS IS VERY DANGEROUS.... PEOPLE WILL FUBAR THEIR SYSTEMS... PROCEED WITH CAUTION. DO NOT FIDDLE SETTINGS!!!
-methods
Here is what I have so far:
* Post 2015 the unit was available in IP65
* Units come pre-programmed with basic settings from Sevcon - some assembly required.
* DVT/Helper/CAN/Display Settings can be used to view and modify settings (be sure to set your node address correctly)
* If you know your index and sub index virtually any setting in the controller DCF can be modified.
Things I have yet to confirm:
* The unit can take a controller in and out of PreOp
* The unit requires Sevcon support to change the logo and splash screen
* The DCF can be saved off and manually modified (did this save yesterday, took forever, today I will poke around in it)
* Modified profiles (DCF) can be loaded back into the unit
* Unit is highly programmable in terms of CANopen behavior.
* Unit can be tailored to match customer standard setup... by hiding unneeded values... and exposing others. This will take many hours to get right, but once done, should be as quick as any other DCF flash.
* ThunderStruck-EV has posted quick start and programming manuals. These manuals are enough... but forget to tell you the tip above about accessing via DVT.
* There are 4 levels of programming access that can be applied via a hexadecimal code. These levels affect what your customer can and can not change. These expose things like Back Door and Personalities. THIS IS VERY DANGEROUS.... PEOPLE WILL FUBAR THEIR SYSTEMS... PROCEED WITH CAUTION. DO NOT FIDDLE SETTINGS!!!
-methods