Are the V4 torque plates available for sale yet? Didn't see any in the For Sale section.
Kiwi wrote:Thats Callums bike from the Thunder Bike shop. A pretty nippy set up on that.
Kiwi wrote:Nice work! I was about to design one of these, but now I wont bother. I have Nuvinci rear dropout adapters designed, available in 2 weeks, so with your mid mount and a nuvinci at the rear, some sweet Yubas to be had.
snowranger wrote:UCS. I've got the developer's nuvinci hub and a yuba frame and hope that kiwi can come up with some good axle adapters. I'd like to input up to 2,500 watts into the nuvinci. Is you mid drive capable? Thx.
Alan B wrote:Very nice work.
I'm considering a V4 Mundo with two rear hubmotors. One in the rear wheel, and one mounted just forward of the rear wheel driving the rear wheel via 1:1 cogs and chain. The cogs would be mounted on the motor disc mounts. The motors might be a pair of HS3540's. Do you think there is room for the chainline? Would it be difficult to mount the forward motor?
Users browsing this forum: No registered users and 10 guests