Hello Experts
I have been using my new ebike for about a month on a daily basis.
Yesterday, i begin to experience an issue of motor not spinning when I press the throttle while riding. I let it wait for a minute or so and the throttle effect is back again. Else, even though the power indicator is showing sufficient battery capacity, and LED lights, buzzer are working, the throttling is not functioning , as if its not pressed at all. I pressed a few times and it still does not work until i wait for a short while and then its back functioning again. This goes on intermittently.
I tried with a fully charged battery and its the same issue.
How i use the throttle is i peddal for a short while and then use the throttle to boost the speed for a while especially when nearing slopes . So, its like 50% throttling from point A to point B that is a range of about 6km per trip one-way.
So, i have been rather gently and thrifty on the use of the throttle. So, i am not sure is it the controller is overheated and disabled the throttling until its cooler again?
Could it be the throttle resistor is worn out?
Is there any known reason for this situation / problem?
I have been using my new ebike for about a month on a daily basis.
Yesterday, i begin to experience an issue of motor not spinning when I press the throttle while riding. I let it wait for a minute or so and the throttle effect is back again. Else, even though the power indicator is showing sufficient battery capacity, and LED lights, buzzer are working, the throttling is not functioning , as if its not pressed at all. I pressed a few times and it still does not work until i wait for a short while and then its back functioning again. This goes on intermittently.
I tried with a fully charged battery and its the same issue.
How i use the throttle is i peddal for a short while and then use the throttle to boost the speed for a while especially when nearing slopes . So, its like 50% throttling from point A to point B that is a range of about 6km per trip one-way.
So, i have been rather gently and thrifty on the use of the throttle. So, i am not sure is it the controller is overheated and disabled the throttling until its cooler again?
Could it be the throttle resistor is worn out?
Is there any known reason for this situation / problem?