smeagol222
100 W
Ah yes internal resistance testing. How do you 'class' yours? What numbers should I be looking out for?
Another issue I've run into the the new 1/0 cable is fitting into the SB120A terminal. I guess I could prune a few of the strands to fit inside then hammer crimp.
I'm wondering if I should just leave it at hammer crimps and not bother with soldering at all- or if its possible to do both, solder then crimp? I would think crimping after solder would break the bond I'd just made with the solder?
Another issue I've run into the the new 1/0 cable is fitting into the SB120A terminal. I guess I could prune a few of the strands to fit inside then hammer crimp.
I'm wondering if I should just leave it at hammer crimps and not bother with soldering at all- or if its possible to do both, solder then crimp? I would think crimping after solder would break the bond I'd just made with the solder?