drewdiller wrote:the CA read 39.2V (it's a 36V pack).
did you get to ride today?
I got 13.6 miles in today, mostly WOT with top speed of 26.4mph and 7.4amps consumed. The amp draw was really high Wot like 16 amps at 22 mph but about 3.5 at 12mph. Most of the ride home was WOT about the last 5 miles so I could check temp of hub and controller. Cold on both next to no heat on the hub and the controller was cold. I guess it's too cold to generate enough heat to tell. I would think if the controller was overloaded it would of shut down, 28.9 max draw on a 6 fet controller with mods. I rhink I'm starting to like these CUTE things after all.Not as fats or as strong as my DD hubs but they sure pedal nice, no drag or cogging as we call it. The sticker from ECITY says it's a 128mm rear 500w 36v for 20" wheel, I did tell them that it was for a 20" wheel so I would get a lower wind, if that makes any sense. So far so good more miles tomorrow I hope, it's going to be above freezing to morrow 33F!!
Kevinator wrote:weird, bmsbattery.com is empty...no products listed. Bummer because I was going to order a cute motor.
The Stig wrote:So far does anyone have an opinion as to which one is better: a bafang or a Cute 128? At the moment I have what I believe to be a bafang which is run at 24V and goes almost 20mph. 350W.
I'm more interested in the cute 108 motor myself so I'm wondering whats the most power you can run through these things? I'm thinking of running dual cute 128 at 55V and 20A each. Not sure which winding.
Users browsing this forum: No registered users and 13 guests