Thanks for the props guys,
No answers for my questions? I will asume (very dangerous) that it looks about right.
"man you elevate working to an art. you actually put down a towel on the kitchen table so you don't destroy the table? or is that the carpet? hehe."
LOL, this is my "Lab" literly a 4' x 6' room eeked out in the basement for me to tinker in. Its all drywalled & echos teribly. (listen to how loud the video's I shoot in there sound) I will take a sweeping shot & show you that the towel is so I can "work" on top of another layer of projects
The 6 fet board is well documented in schematic form. But finding specifics regarding others modding attempts is tough.
Another specific list of questions, Thanks in advance.
#1 the power resistor R1 is the only thing powering the LM377 12v regulator, as I see it the 5v buss runs directly down line from threre.
Q: Since the 116 chip is so easy to program, do i need to modify any resistors to affect LVC?
(as described in detail in other threads)
I am assuming that the LVC programing function will act as a back stop if nessisary. (really a moot point as this is not going to be used as a distance rig that would get anywhere near LVC points...Just curious)
Also to defeat the "saftey current"circut (that was causing the 1/4 throttle cut out issues) I am programming this using the 12fet setting & adjusting the values acordingly.
Any one care to school me on all the ramifcations of this trickery? It would be a nice disscusion
So, unless I hear diferently soon, I will be fireing this up with a single R1 mod to get voltage & current to something the LM317 can handle.
So if I drop...Lets say a 1k-3ish watt resistor in R1, I am good for 24 cells (88.8v nominal). Ohm's law, don't fail me now!
So other than my education, is this thread of any use to anyone?
Thanks Again for all the help & encouragment ES. Thud.