recumpence
1 GW
Swapping two motor leads is the proper way to fix it. Motors do not have wires that are polarized (wire color) a certain way. I just ignore motor wire color and do a rotation test.
Matt
Matt
You have a BEC so the servo-tester only gets 5-6 volts? correct? Other wise you fried the tester with the 25volts....RC_Kiwi said:cheap hall throttle (I hope) Turnigy Servo Tester and on 22.2V (6S Lipo). Any Ideas?
Thanks
RC_Kiwi said:Here.
RC_Kiwi said:Not having much electronics experience, can I ask how you would put a 10K resistor from the signal line to ground? Thanks
Tim
Wheazel said:The pictures on the first page doesnt show for me.
Did they disappear for some reason?
motomoto said:What is the deal with the pictures on this thread? Are they gone? I am trying to wire
up a throttle, but it's hard without the pictures. Is there some magic to getting the .jpg
[/quote]Miles said:they are a casualty of the recent transfer between servers...... hopefully, it's only a temporary problem.