damcard wrote:If anyone can tell me what wires to flip to make it run in reverse, it would be helpful. I haven't tried yet.
...With a lot of help from Mr. Lyen...I first found the [schematic] image of the controller on Ypedal's site...It worked on the first try...
boostjuice wrote:I still maintain though that there is nothing inherently unreliable about the standard Headline-Electric controller they are bundled with in the Cyclone kit.
Dingo2024 wrote:did you notice any difference in smoothness of pickup with this controler compared to the headline..is the throttle still 'notchy' at small openings and not responsive through full travel
damcard wrote:Okay, got it. To reverse the direction, I wired it as indicated in the diagram above except for the sensor wires. I wired them as such: motor black to controller yellow, motor white to controller blue, motor red to controller green.
Also, I found to run it in reverse, it drew less amps at no load if I adjusted the timing of the hall sensors. I just played with it a bit. But now it works. -Damcard.
damcard wrote:I do have a question for the masses. I need to run my cyclone in reverse direction. I have tried swapping phase, phase/sensor, and sensor wires. Every combination I find that works runs the motor in the wrong direction. Could anyone suggest how to alter the diagram at the top to run the cyclone motor in reverse with this Lyen controller? Can I simply program the controller to run in reverse? -Damcard
tony67 wrote:Your unlikely to get many responses on this thread as its over a year since its been active. I have the same setup as you and also a lyen extreme controller I can confirm swapping phase wires does reverse its spin. I cant remember which ones but you normally only have to swap 2 phase wires. find below instructions i got from lyen on wiring with my suggestion:
Yellow Red yellow white
Green White try swap green red
Blue Black Blue black
Controller > Throttle:
tony67 wrote:Your throttle wires look off to me, now its several months since Ive been at mine but i seem to remember the
red is pos
white is neg
yellow is signal
Controller > Throttle:
PS i assume your using the oro throttle that came with the kit?
tony67 wrote:Out of curiosity was it a new motor?
Users browsing this forum: No registered users and 3 guests