Andje wrote:Throwing this out to the wind; does anyone know what spacing we would put into the ebike.ca spoke calculator for these motors? Hub Flange Diameter/Flange Spacing is listed on the tech info, i just want to make sure this is correct before ordering spokes.
HX35 Flange spacing; 1.5" 38mm
HX35 Hub flange diameter; 8.75' 222mm
For those of you trying to figure the spoke length, here is the information that you need with the hub measurement. I am not the bike mechanic guy, If you have tough bike question, I may not able to answer yours.
HS3540 or HT3525 rear motor measurement:
3.3mm S (Spoke hole)
232mm DL (diameter of circle through the centers of the spoke holes , left flange)
12.5mm WL (hub width left flange)
232mm dR (diameter of circle through the centers of the spoke holes, right flange)
17.5mm WR (hub width right flange)
We use spokecalc to figure the spoke length, the spokes that we use is 168mm with single cross pattern, this will work for :
Alex DM18 26â€
Alex DM24 26â€
For Sun Rhyno 26â€ add 2mm to the spoke length