If I go with one more washer thickness to space out the rotor even further outbound it will help with the closeness of the rotor to caliper but then I loose the circular support (that sticks outbound from the hub) that the center of the rotor needs to be supported. If I went this route the bolts could get sheared from braking forces I think.
Any help on this one appreciated……….wayne
I am having a problem with rotor rub. The screws from the HS 3540 outer hub casing are rubbing on the caliper housing. I have placed some washers between the rotor and the hub before bolting the rotor onto the hub which has helped. I still had to file down the screw heads a bit to stop them from rubbing. Any one else had this problem. I am guessing it is this Shimano disc brake assembly that may be a bit wider than others that is causing me the grief.