nicobie wrote: What would a guy use to thread the ends.
Microbatman wrote:What is the measurment in mm of the outside of the threaded axel?
I am trying to figure out if these are standard 9mm bike hubs.
I read that the standard quick realease axle fits but am worried that the outside diameter is too wide for standard 9mm fork dropouts.
nicobie wrote:Did you ever get a chance to try those 3" gazelles on one of these rims?
Stevil_Knevil wrote:H-series rear motor:
Hub Flange Diameter = 233mm
Flange Spacing = 33mm
Spoke Hole Diameter = 3.15mm
FEMCO 1.20 X 17 rim:
Effective Rim Diameter = 418.5mm
Do you have one of those Cyclo spoke threaders, Neil? Could you measure the I.D. where the head attaches to the tool shaft?
http://weldtite.co.uk/products/detail/s ... g-head-12g
Users browsing this forum: migueralliart and 3 guests