sk8norcal wrote:looks good, very nice...
hopefully that headtube weld will hold up...
Brentis wrote:Great job.
I am always impressed with custom rides.
I like the look a lot.
I hope you aren't offended by me using your pic/suggesting a mod.
Consider a brace from seat post, to frame. On each side.(red)
To help distribute rear suspension forces.(BlueGreen)
There is a lot of stress on the seat post(white circle).
Maintains an open look.
Thanks for all the pics
I'll stay tuned for final battery setup.
EBJ wrote:Oh, I also agree with Brentis.
I'm sure you can figure out a good way to brace it and still have an easy battery-cover access.
You don't have to put a big beefy brace in there, but I think it really needs something (it could even be bolt-on)
Hi, found this thread by accident, thought will post here about my issue with this BMS and somebody might have a solution for me. I have all hooked up and it looks like BMS isnt working. When i connect + to BMS, charger kicks in for few seconds and goes out and after about 10 seconds dose same and stays off. When i hold + wire to bms between my hands (being bms in one hand, battery in the other) it starts working ok. It is some kind of mystery.
I am using it on a123 20Ah cells in 12s configuration with 5a charger. All cells range from 3.3 to 3.36 volts. Any input would be welcome.
agniusm wrote:Have rearranged battery for better BMS access if things go tits up:
Users browsing this forum: No registered users and 5 guests