Didnt take that long once joining the forum, my bike is almost ready.
Turnigy AerodriveXP 170kv 3250
Hall sensors
4x 22.2V 5000mah
48v 350w controller (cuts out when I give any juice)
Reduction drive unit
Motor has 16t pully which drives a 72t pully which is connected to a jackshaft, this then drives a 11t sprocket which turns the rear sprocket 65t.
Im well happy I have gotten this far fairly quickly, with the help I must say from a member on here.
I just got the chain put on today and strapped the battery onto the frame with duct tape, Plugged everything in and went for a test run in the garden.
The controller just kept cutting out when I gave it any juice, it does spin a little then it cuts out. I have been told there are solutions for this hopefully it will get sorted.
Anyway here it is.
Turnigy AerodriveXP 170kv 3250
Hall sensors
4x 22.2V 5000mah
48v 350w controller (cuts out when I give any juice)
Reduction drive unit
Motor has 16t pully which drives a 72t pully which is connected to a jackshaft, this then drives a 11t sprocket which turns the rear sprocket 65t.
Im well happy I have gotten this far fairly quickly, with the help I must say from a member on here.
I just got the chain put on today and strapped the battery onto the frame with duct tape, Plugged everything in and went for a test run in the garden.
The controller just kept cutting out when I gave it any juice, it does spin a little then it cuts out. I have been told there are solutions for this hopefully it will get sorted.
Anyway here it is.