dogman wrote:Chances are, thick enough even if somewhat lower quality steel. But 41 bucks to ship? Ouch!
dogman wrote:Bear in mind this is the version one torque arm, that is suitable only for non suspension front forks. Alloy front forks have larger diameter, and require Justins second version design to fit well, and definitely you also require c washers for an alloy front fork.
Sometimes the axle piece of this design can be used on the rear. Very often people bolt them on the rear, but it's done in a way that renders the install more or less decorative. What I mean is, if you look at it closely, you see that any rotation of the first piece applies a load to the second piece that will merely slide the hose clamp down the stay. They need to weld the two pieces to prevent this, or have it bolted to the stay, not hose clamped.
1. what metal are the torque arms ? stainless steel
2. What thickness ? 3mm.
Do those fit snug on the axle, btw?
Hyena wrote:I bought a set of these to try a month or so ago with some chargers so the extra shipping was negligable. However the ones they shipped me were tiny and don't even fit a 12mm axle
Users browsing this forum: Bing [Bot], MSNbot Media and 8 guests