I wanted to share with you the process of convert 600W electric skateboard to RC equipmentThe equipment:Motor :
Hacker A60-16L 168KVController :
RC Cars 150A sensorlessBattery :
6S 20A totalThrottle:
WII Nunchuk First step:
The board was old and ugly, I peeled the top coating and sand it.
Then I did the wood repairs, and a thin layer of epoxy. After the epoxy has dried sand it again and got a very smooth surface.Next step:
At this point I covered the surface with carbon
I put Epoxy on the wood , then carbon on the surface let it absorbed the glue .
After drying I cut the leftovers and sand. It is important to put super glue on the corners and sand again to ensure coating will not hurt the rider and will look good after long time...
After assembling the wheels it looks good
The next steps will be the motor mount and sprockets..