adrian_sm
1 MW
Hi,
Is it possible that it is all working perfectly, but the CC ESC just needs to be taught the new throttle range. I haven't used CC ESC but for my ESC's you have to:
hold full throttle, turning on the ESC, waiting for some beeps, then adjusting to minimum throttle, more beeps, then it is done.
Hope it is this simple.
Otherwise it sounds like the servot tester is getting 5v in the right spot if the LEDs light up. Do you have a multi meter to check voltages? If so check that you are still getting GND & 5V through to where you plug in the throttle. Then check the signal voltage as you adjust the hall throttle.
Good luck.
- Adrian
Is it possible that it is all working perfectly, but the CC ESC just needs to be taught the new throttle range. I haven't used CC ESC but for my ESC's you have to:
hold full throttle, turning on the ESC, waiting for some beeps, then adjusting to minimum throttle, more beeps, then it is done.
Hope it is this simple.
Otherwise it sounds like the servot tester is getting 5v in the right spot if the LEDs light up. Do you have a multi meter to check voltages? If so check that you are still getting GND & 5V through to where you plug in the throttle. Then check the signal voltage as you adjust the hall throttle.
Good luck.
- Adrian