ericbojo
1 µW
- Joined
- Apr 26, 2013
- Messages
- 2
I'm 90% sure the controller is fried on delivery.
I tested my battery its showing 55 volts at full charge. There is no longer a pop when I connect the controller, it only happened the first time and not after. I did connect the Ignition wire to the positive terminal and still nothing. There was literaly Zero instructions on setting this kit up..
One of the wires to the motor from the controller side was loose (blue thick wire from the 3 pin connector) and i re did that pin so it connects properly but still nothing.
I hooked everything up and i got no voltage to the motor wires when i use the throttle.
I checked the controller directly i do see voltage at the terminals but no where else in the controller, with or without throttle. So I'm pretty sure this controller fried and never properly tested in the first place.
Can anyone recommend a better controller and wire connectors/terminals to use? I'm really unhappy with the workmanship on this controller and it shows how little quality they put into their products..
I want to get a better controller but need a wiring diagram to hook it up properly with the GNG motor.. Also if you can recommend a better thottle I would appreciate it.
I tested my battery its showing 55 volts at full charge. There is no longer a pop when I connect the controller, it only happened the first time and not after. I did connect the Ignition wire to the positive terminal and still nothing. There was literaly Zero instructions on setting this kit up..
One of the wires to the motor from the controller side was loose (blue thick wire from the 3 pin connector) and i re did that pin so it connects properly but still nothing.
I hooked everything up and i got no voltage to the motor wires when i use the throttle.
I checked the controller directly i do see voltage at the terminals but no where else in the controller, with or without throttle. So I'm pretty sure this controller fried and never properly tested in the first place.
Can anyone recommend a better controller and wire connectors/terminals to use? I'm really unhappy with the workmanship on this controller and it shows how little quality they put into their products..
I want to get a better controller but need a wiring diagram to hook it up properly with the GNG motor.. Also if you can recommend a better thottle I would appreciate it.