Recent content by artvk

Thank you for sharing this ! Admire your built and youtube vids :bigthumb:

Did you try email to Mobipus factory for password and initial setup ?

" thermally conductive epoxy resin " what brand name you recommend for dielectric one ?

Hi I have Kelly controller and would like to use CAN dbc file output for display monitor. Wonder if you anyone could share Kelly CAN DBC file ? Thanks ! Here is another project using Mobipus 72600 controller CAN output to AEM DigitalDash display yaohthRxEXM Art

Quick update with AEM Dash using CAN input from controller yaohthRxEXM

Hi Im looking to buy authentic Sony VTC6 from good suppliers. Normally im buy from EVVA but their stock back order for long time. Much appreciate for all suggestion

Continuos 150-180 amp. Peak around 350amp for short period. Here is the terminal

Here is my finished pack for copper and nickel spot. 20s20p

mDdR6e-Z3kU Have a chance to test ride with enabling field weakening today.

YG4YpyhBbo4 some test ride with data logging

Front11T Rear70T

Just have chance to do the dyno test. Im testing 82v and 500Amp for turbo mode setup for this result hp and torque below. Note* I'm matching rpm of motor with the dyno unit since it the rpm matching was not like combustion engine.

Thanks Im in Bangkok. :thumb:

The controller have extra wifi module that able to link to Windows based device. As I checked, these 6-8 inch Windows tablet are all obsolete. Both Dell Venue and HP Stream 6-8" screen were all obsolete.

I use Dell Venue tablet. The Mobipus 72200 can send data to tablet by using their extra wifi module.