Hi all!
I bougt a kuberg freerider in a not so good shape, Fried 12kw controller (will pair it with my Nucular 24F) and hallsensors not working in motor. But I´m very excited to take it out for a spin.
So its a Hall sensor board with three sensors.They are marked with "A 04L"
I think this is...
Looks like some really nice motors, will contact them to see what it would cost but I'm afraid it's going to be outside our budget. Axial motors seems capable of producing a lot of torque for their size. I wonder why they are not more commonly used?
Thanks everyone 🙂 :thumb:
It's mainly going to a wind turbine a couple of kilometers away, on the way there mostly up slope. Then there is 22 kilometers way and return to a cabin in the mountains 400meters of elevation if i remember correctly. But much more range than that is not necessary...
I have been asked to help convert a Swedish military 6 wheel truck to electric. Its going to be a transport vehicle for off road use only, not registered for road use, top speed not very important, weight not very critical and range some where around 60-100 km (37-62 miles)
Here are some...
"On the brakes, which I use a half twist (a full one cut off) on the left grip, I have adjusted the max voltage lower on 2 of the bikes, so less twist is needed for full braking. I cut the brake throttle quite short (just an inch or so) and use a grip with a ring and allen head bolt to tighten...
Hi. What could be the reason that the mosfets on one phase gets shorted after I engage the throttle?
Inexpensive chinese controlller so no big deal but It would be nice to have a bike until I get a better controller...
thanks in advance :)
Hi all!
I have got a Dapu M155 rear hub motor with the cables getting stuck in the rear sprocket, one phase wire and the green hall wire probably shorted together, see photo. I get a normal 0 and 5v reading on blue and yellow sensor and the green one reads 5v constant when i turn the wheel, so...