Hey
For all those who received Dave's outstanding second gen 6KW Tangent, can you give me the cycle analyst settings for "Setup Calibration" that was installed when you received it from Dave?
Slight finger issue...lol...
Looking for the following settings:
Setup Calibration (for Hi -> Range)...
You should look at Grin's Trip Wire ebrake sensor (http://www.ebikes.ca/shop/electric-bicycle-parts/ebrakes/tripwire-push.html#). I use this on my bike without any issues and it is a nice clean set-up.
My understanding is if you plug the three connectors from the motor to the ESC and the motor runs backwards, just switch any two of them and it will work. Happened once to me and this i what Dave told me to do.
In theory, I believe the tensioner Dave designed is the way to go as it is simple and easy enough to adjust, remove, etc. But it could use a more robust spring in that the current spring isn't strong enough to keep steady tension on the motor chain.
Thanks.
I have Dave's first gen 6kw tangent and I currently use EM3Ev's triangle battery (High Power-25R 50.4V 22.1Ah 1111Whrs ~40A ~80A 6.4kg) in my backpack and although I don't get the full benefit of the 6kw, it works well enough for me to get 45-50 km/h while in PAS mode (PAS sensor hooked up to my...
Hey Dave
Still looking at pre-orders in December or will this stage be pushed back until the new year? Very anxious to get my hands on the second gen 6kw Ascent. Thank you for the updates and tireless work improving on a immensely well engineered mid-drive.
I have a 50V Triangle Pack 22.0 Ah 25R with about 20 cycles on it. When charged 85%, it powers my mid drive while on a bike stand (rear wheel off the floor and no load) with no issues. The mid drive works perfectly with no error codes from the controller and nothing out of the ordinary on the...