Recent content by dagher58

I retested voltage directly from the pad where the 6 pin CA-DP wire connects to the CA board and read 0v again, I reached out to grin directly and it seems I have finally located the issue. After updating them with where I was at and linking them to this forum for more info they replied telling...

Okay so I just started playing around with the CA3 on my bike and it seems I forgot to plug the Neg wire from 6pin CA-DP Connector to my sabvoton throttle when I was running test last night after putting my CA back together lol. Back to testing we go. I just opened it back up to test for any...

When I mentioned "CA3 Throttle Connector" I was referring to the throttle input in the image you linked, I guess it being an "input" makes sense why I was reading 0v on Sig (Green). The 5v wire is *not* hooked up between the controller and the CA, but the signal (from CADP connector) and ground...

I'm not sure what happen with the Hex file as it sounds like it got corrupted but I setup a new one making sure it was for firmware v3.14 and with all the settings as accurate as I can set them and will attach it below. I reuploaded the new settings to my CA today and ran a few tests but still...

Hello Amberwolf and thank you for your reply, I definitely meant "indirectly" it goes through the CA first then the throttle output wire is connected to my sabvoton controller throttle connector. My controller doesn't have a CA-DP connector so I had to set it up to an external shunt. Ill attach...

Hello ive been testing and digging through endless sphere and the unofficial manual for the Cycle Analyst the past few weeks and still had no luck getting my throttle to work when plugged directly through my CAv3 E-Bike Specs: 72v 40AH Battery 150a Sabvoton 72150 Controller 8000w QS 273 Hub...