Recent content by dzecs

Yeah, I emailed with the .de place, but I think I'm gonna take your advice and just cut/solder to a wire with a JST on the end.

Hey, sorry I'm such a noob, but could you explain what this means?

Thanks for the advice folks. I did contact the .de site and will be looking into soldering a connection myself. How about the 2 brake for one input issue, how did you deal with that?

I just got a set of Magura MT5e brakes for my cargo bike conversion. They have a Higo 2 pole connector on the end of the wire coming from them. I am trying to figure out how to connect them to my Cycle Analyst that has a JST connector for the brake cutoff. There is enough distance between the...

Thanks for the advice everybody. I'm leaning heavily towards an Ezee system from Grin. As motomech was saying, its best to get a system put together from one vendor, and I like the ease of communication with Grin. The kit includes the motor/controller/CA V3 and Torque Sensor. I was thinking...

So, the frame is a Yuba Supermarche, if you look carefully at pictures of the frame, the chainstays are eccentric in a very odd way that I do not think would fit a mid-drive, in addition the tube that goes anteriorly from the bottom bracket is horizontal with the ground and already quite low...

After doing a lot of reading here and elsewhere, I think I've settled on a moderate power, geared front hub motor for my cargo bike conversion. The three that I see mentioned the most are the BMC, the MAC and the Ezee. I have had a hard time finding any threads that compare the current...