Recent content by eMoto18

I know, thanks. That's why i took the pic. :wink:

I did it 😊! It works with a puller, rust remover and a little bit heat from a heat gun. Thanks a lot for your advices.

Hot water is a good idea. This ferrite ring is like ceramics unfortunatly. I think first i try Aceton, if it don't works, than hot water. I've now managed to remove the Rotor, so it is much easier to work on the ferrite. I will report how it works.

It not a difficult job, the rotor can stay at his place. The bearings are in the lids, only the ferrite is the problem.

The ferrite ring is glued, I think it will break, if I use a puller.

Hello guys, I need your help. I want to rebuild a mid drive motor with new bearings. My problem is, I can’t get out the bearing without removing the ferrite ring for the hallsensor. I think the ring is glued and I won’t damage it. What’s the best way for removing it? Thanks a lot.

I bought two times from ebikeparts.at. Very good Dealer and fast shipping :thumb: . On my second order, some part was not on stock. They immediatly informed me apologized and offered me another part, as it cost more, they gave me 15% discount. Great I'am from Germany