Recent content by Florida_rosbif

My project started with a Miami summer. As many of you will know southern Florida in summer is hot as hell and humid, to the point that, for a European like me, I consider myself to be a prisoner of AC. Unfortunately my little garage does not have AC, so my ebike build came from a desire to have...

Well if the test voltages don’t come close to matching what is listed as the required outputs for that circuit then something isn’t right. In CA3, set up Aux Analog, 3 pos switch, power lim (that’s what I chose to use, other options available). By default high is 99% at 4.99 V, I.e. 99% motor...

Appendix G2 gives the interpin resistances to check before you “wrap” your circuit. Did they check out ok?

You sure that you have no shorts in your resistor wiring? Mine didn’t work first time - that’s how I learnt that heat shrink tubing exerts a lot of force on the wires and had managed to push a soldered joint through the insulating tape so that it shorted out on the next wire. Did you test your...

I bought a generic 3 position switch on AliExpress only to find that it wouldn’t work with CA3. Bought a $7 selection of resistors online, cut the wire, then spliced it all together as per the drawing in Appendix G, section 2, custom DIY 3 position switch. Works perfectly with CA3, plug and...