Recent content by iacei

I think it is wired to the battery via a special pin that gives current only when console sends the signal but as there is no communication anymore between the console and the Battery it does not work anymore. Here a pic of my ongoing Battery replacement It will have an extra switch on it...

Ok it works!!!! I wasn't pushing enough on the pedals to start the motor. Fun Fact, the lights do not work or is there a light sensor that holds the lights from shining even if turned on? Diagnostic Mode gives Error 00 30 26 which is normal: >> 26 = No communication between Console and...

How do you check the diagnostics? found it: https://electricbikereview.com/forums/threads/how-to-get-access-to-your-bionx-console-code-menu-codelist-included.519/ I have G2 console

Hi again, Here the picture of the bike and my test battery, for the moment the display goes on but the motor does not start. Any ideas?

Hi, I am currently doing this conversion for a friend with a busted bionx Battery, I will keep you in touch if it works.

Touch sensitive gloves!!!!!! This winter I was very happy buying new gloves because my hands were freezing ....until I had to use my phone (with osmand) Damn! 35€ trashed. I tried sewing conductive wire to my finger but it does not work very well....or I am bad at sewing :lol: So if you buy...

Hi, I just updated my nucular display and controller, it went ok, some parameters had to be set up manually like the FOC mode for the motor and the wheel circumference but other than that I am pretty happy. One question: My bike is currently configured with ebrakes and I wanted to know if...

Just came back from my 1st test with the battery (even if its freezing 0°C): Eveything's great! I have a steep hill for testing and with the stock battery to stay around 40Amps the motor had to slow down or cutoff (depending on the parameters) now it's withholding 70Amps without issues. I am...

Almost ready! - As you can see with 2P more the battery is comparable in size with the original one. - I will need to add padding to avoid it to move - When I charged it I saw that the stock lmx charger charges only until 90% (which is good and Bad) which explains that I was in need for...

Good times! my BMS and nickel strips arrived today, I can continue my battery

Hi, I have ran out of nickel strips so in the meantime I will have a go at a nucular update (display + controller) Can someone share his settings with a recent version of nucular? https://nucular.tech/firmware last version: - Display: 0.60b (mine is 0.57b) - Controller 0.7.18 (mine: 0.7.9)...

Hi folks, good stuff has arrived in the mail and I started building Half a battery: Good news, it seems for my 14s7P Project it won't be necessary to make a 2 part battery, just make it like a parallelogram and you can slide it in the bike (still other tests to make) Maybe this...

Hi There, Finally winter is here and so the time for me to go back to my battery project for my LMX64 M frame. I finally decided to go for a 14s7P with Sanyo cells (10A 3350mAh) The main reason is that with my supplied 14s5P with Samsung 35E cells (3500mAh / 8A), I have only 40A continuous...

found it here: https://www.aliexpress.com/item/4001223379820.html

How can we tell if we have a 30mm or 40mm stator from the outside?