Recent content by kadleca

Hello, VLDC5 is in the night very shining. Can I turn off the display in some vay ?

Does somebody know if or how are the input circuit guarded? Does somebody have a schematic of the input circuit for programming?

I have similar problem, i can not programming my 2 controleres now. It started when i was sucsessfully programming but if it was ended my laptop power off. Now it is blocked with the same pop up window. I tryed programming in another tsdz2 with the same results. But fortunately I have an wery...

Attenation .The ST Programmer can be inhibit for three wire communication. I described how to unbloced it.

Try this, open only STvisual programmer and try to read data if it is fails, there is pop table, on it is written what to do. You should connect RST with GND on ST- link and turn off the STvisual programmer then turn it on, with connected RST and GND. After that release RST-GND and try read...

I had similar problem with reading speed sensor. It was with the original firmware and the help was seting distance speedsensor. It was wery near the magnet.

There is a small tab that can be useful for quick orientation off VLCD5 control

I entered this value in configurator enabled “Torque sensor adv. on startup” and "torque sensor calibrated" and flashed it again. The new .ini files I renamed and saved. I used the poor man flash conection with three wires, it is easy . I have two TSDZ2. In the 5-yaers I had to change...

Thank you Elinx. It is exactly as you wrote. My min. value is now 170 and max 280. Now the assistances are working properly. Do I have to let the Torque sensor adv. on startup enabled or does not matter now? Best regards Antonin

Hello everyone, I am trying to set up torque parameters on VLCD5 display but it does not show any data (assist 4 2+2+2 extend by 2 ). Torque sensor adv. on startup is enabled. There is E02 error. on start up. I seted the ADC offset 25 and ADC max. 60. It is working but I do not know real...

Hello, I am new in this forum. I have 5 years old TSDZ2 motor with VLCD5 display. Two years ago the Stock firmware started to have problems with initilizing. I had to tray a few times turn it on and then it was making OK. It was worse and worse. I instaled the last OSF, it looks good but the...