Recent content by louis raaijmakers

nice motor! i cant help you with the software. but i am also looking for assistence to program the 75-7 motor to 2 controllers to work as a team.

hello, for my build (crosskart) i am ussing 2 sevcon gen 4 size 6 controllers, (complete driveline from zero dsr motorcycle). but now i want the 2 motors to work/act the same. i want the to work as one "slave" and one that takes the input from the trottle. offcourse not for free, if you can...

here i am again, i worked for a few months to get some cash flow going. i have replaced the input bearing from the diffrential, had some pitting due to turning the axle and not cleaning up the water residu... now rebuilding the chain drive to 2 420 or 520 chains. but mainly looking for an...

cool build folowing! :thumb:

great vacation, nice weather and beautiful nature. did some very nice trips on my motorcycle there! Whow brac is even nicer :shock: . that for next year!

What you can do to get two motors paired on the same axle is to mount them on the axle and brackets with some adjustment range, then align the motors by energising the same set of phases in the same direction with a dc current. It will move the motors to the same alignment. Then tighten your...

thanks for the reply! cool shots damn! oke now i know why it needs to fit in a truck. :thumb: i will folow the build

very cool project! but where will it be used for? just curious. greetings louis

thanks i am hunting one down!

for the specs it could handle that no problem. my next consern is the chain "Bends" allot of times in this setup what causes heat in the chain. and there so shorting its life time i guess... so maybe a oil bath would work better of 2 seprate 420/520 motorcycle chains to reduce "bends"

brilliant build! been thinking about building a motorcross/enduro bike quite a bit. to replace my ktm 2015 exc but. after reading this tread i am going to back that idea off :roll: good luck with the build i am folowing!

i have the older version where you dont need the expensive software for. but i do know Sevcon software is not software where you just go on and change some parameters and it all works. it is a very very complicated device. and has endless possibility's with a good programmer. but i will...

yes the are Sevcons size 6 gen 4. but with zero software. not sure if it is smart to start with a new program. (i also think you cant just go into the sevcon without a licence) i do have the old xiatt to program size 4 gen 4 Sevcons for the scooter of my brother (govecs) but thats a "normal"...

back to school. first days are done with the exam's but new problems for the project accor. how do i get the Sevcons to work together? i wanted to split the throttle wire and send the same signal to both controllers. but this throttle has 8 wires.. and not the usual 3/4 wires. i am guessing...

and we are back on the build. i made a jig to hold the front A-arm on the desired place so i could make mounts to hold them. the laser cutter a school helped my out, that was the last day school was open after that it was closed due to vacation. rear end assembled, the shocks are from a ktm...