Recent content by mccloed

Or, you could contact @Psychotiller. Check out this video of his supposed "Evolve Killer". https://www.facebook.com/DubbleDirka/videos/10208599312914927/

We have run the VESC's on 8 and 10s with 230 and 245kv motrs without an issue. It seems to me that the VESC's like 10s. Even on 8s I had to run a fan to keep the power from falling off from heat. On 6s the power would drop off quickly because of heat.(I know some people run on 6s fine...

I do not use one ,myself, but most people that have had one have told me that they eventually stopped working and stayed in the on position. I just use the anti-spark loop key. Where did you get your switch from?

So am I ok to use without sad caps as long as I don't run it in FOC? I have caps coming next week.

looks like the shunts say WSLP2726 .0005 OHMS 1% 1622

Thanks for the heads up! Wasn't planning on using FOC, but now at least I wont blow them up if I decide to.

Good call. I'll check before I ride. Here are some pictures:

Got the VESC yesterday. First look: Looks cheap. I'm not sure what kind of DRV is normally used but this has the Texas instruments logo on it. They also used vedders capacitor pcb with the three capacitors. The phase wires are only 16 gauge and the power wires are 12 gauge. They heat shrinked...

Always delays! They are actually shipping them to me this week.

I ordered some Chinese VESC's. You know, for science. I'll let you know how it goes. I am used to being the "guinea pig" :|

That ones probably decent. The SK3's have a 6mm shaft. That one's going to have an 8mm shaft. Which I prefer.

I actually purchased a couple from these guys. Should have them next week. I'll let you know how they are.

I guess the FVT can only take so much. :lol:

That sucks. Personally, at 6s, I'd rather use the FVT. Did you use @bandaro's firmware or @weechumlee's? I used @weechumlee's and that's the one that worked.

Eeew. I may have a different skate version than what is linked here. It worked fine but I don,t like it. But, if you can't connect to the USB your probably out of luck. :( Are you going through the LCD program card or the USB link?