Recent content by NisseMan

Thanks , I will use this frame: https://vi.aliexpress.com/item/1005001469804887.html?spm=a2g0o.cart.0.0.4e8838daLL9gz5&mp=1&gatewayAdapt=glo2vnm 68 mm BB, 135 mm width. Light use so an geared hub drive should fit my needs

I am building an Kodsa mini velo with 20 inch wheels. I like to have rear hub motor with an bottom bracket with torque sensor. Any advice on what motor/bracket etc to get?, no need for high power, 300-500W should be ok

PAS only?

My commuter bike, Scott E-Sub 2017, regular maintenance. Tyres, chain,drive cassette, brake pads etc.

I have an Scott e-bike with a Bosch active line mid drive, Using it for 40 000 km soon and motor still run flawlessly

Bit off-topic, but have anyone seen any adapters for M500/M600 mount on Bosch Gen2 bikes?, My scott e-bike has burnt motor and stock motors is hard to find. Would be an option to attach an M500/600 instead

Its a pity the hardware is subpar, there no real option to the TSDZ2 in this price range. An rear hub with added torque sensor is the low cost option that comes to my mind

I got few 6902 bearings, any other that have high load? The new bearing seems slightly to big, the shaft don't have correct diameter. I think i will strip down the motor and fix it, plasma spay the shaft to fix the diameter.

Any complete list of all the bearings?

Had to open my TSDZ2, was almost dry, almost none grease at all. Added some cooling and new grease, sound levels drops and casing get a bit warmer. Jacked up power to 600 W max. Update, motor still pretty noisy when is cold, when heating up after few min its almost silent Update 2; took some...

I have high pitch noise in my TSDZ2, its only 2-3 first min, when the motor gets warm the noise fades down. It been like this from start, it has only run some 300 km so far Normal?

I use 52T chain ring without any issues. It make better use of my cassette, never need to use the 11/12t cogs

https://www.youtube.com/watch?v=dfItwYWTklw Update : Video removed From video: The new CYC model is coming. Some more information: • Ground clearance is better than Bafang • Price is slightly higher than BBSHD, MSRP 950 USD? • Display Option DS103, SW102 (Eggrider Display should work)# •...

I skipped that seal, used some stiff grease as seal. Been running 1 year now without issues

I have to stupid: how do you flash the firmware to TSDz2 for 860c display?, there no java configurator in the source files and ST tools reports all files out of size for the hex-file. What are i missing?