Recent content by quelsurprise

Thanks, sounds promising, I’d thought it maybe complicated and expensive to cut (based on zero to no real experience!) my measurements were way off also, I had the inner diameter at 16 and the spine width at 5mm, appreciate the help!

Really enjoying following your progress! I'm looking to find a way to mount a Gates pulley to the QS180 shaft, I'm getting some steel interfaces cut that will sit between a pulley taper bushing and the shaft, though not sure if this will be the best approach, sendcutsend are unable to accurately...

I've been trying to build something in Fusion360 that would fill any shape with cells, that'll be finished in about 10 years from now ;) There is this one (kindly shared on the Electric Dirt Bike Open Source Design Discord) Lithium Battery Pack Designer - Cell Saviors there's also this pack...

Thanks, I'd gotten this silent chain set up cheap from Ebay to see if it could be used, and had forgotten about it when I knew I could use Gates belts and pulleys, the splines in the Polaris sprockets look the same as the KTM sprocket I have. I guess if I can find a machine shop that can...

Think I just found a matching one, the Polaris XC700 looks like it's the same spline pattern

Hi, do you have any details of what snowmobile the shaft was from? I'm trying to track down something about 10" long that a KTM sprocket will fit on. thanks

Hi, I've been seeing what I can use for the jackshaft set up, and seems like I should be able to go with Gates 8m 21mm Carbon belt and pulleys, think I've figured a way to mount the pulleys, rfndzc advised that I can just use one of the QS180 splines with a key Belt drive conversion on honda...

Not the cl1400, but maybe of interest https://www.electricbike.com/two-builds-using-a-3shul-vesc-controller/

there's this FB one also 3Shul Vesc based controllers Help and Support

Are Alien Rides way more $ for the cl1400? says they have it in stock https://alienrides.com/collections/3shul-vesc-motor-controllers/products/3shul-vesc-motor-controller-c1400

maybe? https://splineshop.com/product-category/splineshafts/

That'd certainly make life easier if it can take the load, it's 20mm diameter

T Thanks, sendcutsend can cut 0.5", so maybe less prone to warping, something like this maybe.

The QS180 has 6 splines, and the useable depth below the clip recess is 10mm, I've been looking for a weld on adapter that fits this pattern, the one I got from the UK is KN16x20 but the female splines aren't wide enough, so was considering cutting steel rings to go between the splines and...

and thanks for sharing the links