Recent content by silentguy

Nice ! I did a kayak build with Minolta trolling motor on side and heavy lead acid battery. It did Ok Motor and battery got stolen out of my storage unit though. Sent from my iPhone using Tapatalk

I put a 12volt trolling motor on my inflatable kayak. Used a marine lead acid battery but was gonna upgrade to lion It went about 6mph You will need to make sure everything is in watertight containers and waterproof connectors as short circuit by water is always possible. Sent from my...

Doesn’t it leak out ? Any chance of Fire ?

If you look at the yt video I made it explains the setting I used for p07. I used 4x12=48 I still had to experiment yo get the correct speed on the speedometer.

Temperature sensor internal and external test drive This is with the copper heat mods. https://youtu.be/DBK68Is0bf4

So what kind of temperatures are you seeing ? You have heat reduction on the motor side too ?

It’s in the pic if u zoom in. There are different thicknesses available. I bought one which was easy to bend. Sent from my iPhone using Tapatalk

Found these at the Dollar Store Not sure about actual copper content , but you could use a few to fill the air chambers.

Crafting copper I found this was better than the copper tape Only $7. Can cut it with sharp scissors. Easy to bend.

Results of my heat reduction attempt using copper. It appears to be working well. I haven’t overheated yet on my long hill , but it’s winter and outside temp is 50 F here. We shall see in summer I also found experimental mode tends to heat up the motor much faster. I stopped using...

External case temp vs internal motor temp. Case was at 100F when the internal motor temperature was 185F. Update ; External case temp is about 40F cooler than internal motor temp. 100F case ; 140F motor. This is with all my copper mods. So if you don’t want to install the internal lm35...

I briefly got it to work by adjusting gear ratio However I think some other issue may have caused the mosfets to overheat. For Now I ordered a new KT controller and I’m using the original non-open source fw controller LSW 1031 and Kingmeter II which works. Try gear ratio ,and also motor...

Can you direct me to instructions on how to turn on motor without lcd. ?

Temperature sensor install problems After installing lm35DZ temperature sensor I have some problems. Bought from eBay Perhaps I wired wrong and Damaged some thing I may have caused a short or wired wrongly I am using 36v motor , 850c display V19 osf firmware on the controller , v05.bet7 osf...

Here’s the translation from google