Hey 12-C,
I hear you loud and clear. To answer your question, no, I have not heard from Dave. I have tried emailing but no use as it comes back un-deliverable. Guess he's out of the ebike game unfortunately :(
That is a real bummer to hear about your chain binding damaging the internal cycloid...
Thanks for the feedback everyone
Chain alignment is good. 1/8" single speed chain is matched to Chris King 1/8" rear cog. Front chainring is a 36t Raceface N/W 104 bcd. It's a little sloppy on the front but overall not bad.
^This is where my brain is heading. Too small of a rear cog and not...
2 steps forward, 1 step back
New brakes and drive train upgrade installed.
Brakes are SRAM Code RSC w/ 203 mm rotors. Beautiful quality, stopping power, and feel. 5 stars. The contact point adjustment is lovely. No complaints here.
Drive train converted to single speed with Chris King 14...
Success!
Got the bike cobbled together with the stand alone throttle circuit. CA removed for now. Finally got the full power from the 3210!
Excuse the mess of wiring. Everything needs tidying up but this was just for a quick test run to see if it would work.
Changes included;
1. CC HV160...
Update;
Making slow but steady progress. I decided the best way to move forward would be to eliminate as many variables as possible. Starting with the throttle.
Following in Matt Shumaker's footsteps https://youtu.be/C7Q9MAUlKX8, I bought an Astro 105 servo tester, de-soldered the 10k pot, and...
Update & Thread Name Changed. Formally "Need Advice on High Powered Mid Drive". Decided to change the name to better suit the subject of the thread. I'm new to this forum so I hope that's not frowned upon. Please someone let me know if I shouldn't change subject name. Thx
After several days of...
Update;
My current goal is to measure the Kv of the motor and compare the 5T specs of the 3210 from astroflight.com to figure out how many turns this motor is.
I'm planning to use the "drill method" to determine Kv... https://youtu.be/JD1gplvhGrc
So in order to get direct access to the motor...
Thank you very much Ham & briangv99, this is great info. Awesome to get some feedback from some fellow Tangent owners.
On the advice of MadRhino and BrunoPOWEEER I pre-ordered the Nucular 12F but it's going to take a while to get in and I want to do some testing and learning about this motor...
After much deliberation I have decided to stick with the 3210 Tangent setup and see if I can get it running up to it's full potential. I think this motor should have the guts to achieve my goals for this bike.
With that being said, I've been doing a ton of research but I'm still struggling to...
Great question! and so awesome to get a reply from spinningmagnets!!
The CA Temperature settings are as follows;
Temp. Sensor Type = Linear Type
Temp. Offset = 0.45 V
Temp. Scale = 262.1 deg.C/V
Threshold Temp. = 150 deg. C
Max Temp. = 160 deg. C
On both test rides I was keeping an eye on the...
Thanks MadRhino & Markz for the input.
I'm trying to figure out what controller would work on the 3210 other than the Castle which I'm already pushing the limits of by running 14s, as well as the motor for that matter... If I'm going to buy a new controller I would like to get one that will...