Recent content by Swe

On my display the Amp value flickers between -0,2A and +0,1A when standing still. Since I also get a negative value I dont think it is the Domino throttle? Could this by a reason for the controller to enter Charge mode? If negative value gets high enough withoud regen. As an alternative theory...

Ok I checked the connectors, I did not see any water but the one to the display was open (not the connection but the cover) so some dirt maybe. Also some dirt on the one to the motor hall sensors. Will se if it makes any different. I also have Neutrik connector for charging but I see nothing...

Okay thanks, I will look over the connectors, but is it any specific connector that it should be regarding Charge?

My Adaptto mini have started to enter Charge mode during rides. Any idea why? If I go to charge menu and press down, the charge mode stops and I can ride again. But one time a while ago that did not work either. If I remember correct I shut the controller off and on to remove it. I have bms...

Do you have to solder the BMS-connectors or is there any other solution? Looks scary to solder these small points. I use the connectors today but they are a bit loose. Not so reliable? Today when I charged the bike at the end I had 4,5V on one och 0V on one paralell. I got a bit scared I had...

No power in eco mode you say? On mine eco mode only works with PAS, and throttle only in normal and boost. Just as it should be...

Is 250W the total on the bike or could you have 250W on both front and rear wheel and still be legal? Edit: sorry did not see this was a very old topic :o

Sounds a bit like mine then, showed correct values the first time after had not been used for several months (capacitator discharged?) then next run back to old again. Though I do not have any stuttering so you have more problems.

Your link did not work for me but if you mean that the LCD3 display shows wrong as mine, I still have not solved it. Once when I left the bike unused for a long time it then suddenly indicated correct on the meter, but like half of the other stuff showed norhing at all. Then on next run it was...

It is not at the bottom, so should not be for water. Strange no one have thought about it. If it really is for nothing at all I will probably clean everything and then plug it.

Why is there a hole on the (almost) bottom of the Beta frame? Think it is a closed area or have I missed something? It is not all the way down (if it was for draining water). See picture. I removed my Hollowtech II to install PAS and there where dirt inside the frame there. So when removing...

Ok did not know that. But thats good I only want PAS in Eco.

I have run it some weeks now on my Mini. I had no problem updating. Only thing is that Eco-mode is not working anymore... but I guess that is because I don't have any PAS installed yet (I have ordered).

That looked much better. Will have to think a couple of days about if I should order or not. Too bad it is from USA, so expensive to buy from there with shipping and all extra fees also. But at least I know it will fit with your modification.

The modification looks nice! But is the kickstand all the way up on the last picture? Looks a little like it has an angle a bit down so it is not aligned with the bike in upper position. No problem when riding in harder conditions?