Recent content by timeride

If I need to fault find with the hub, I've found the tool... https://www.youtube.com/watch?v=Rh2nCfksh3U

I'm resuming my long haul, load bearing project bike but have come to complete dead stop before even starting. So look I'm looking here for some (hits head and says "doh") pointers as to where to fault find next. The setup: BMC 600W Motor, 12 FET controller, thumb throttle, Cycle Analyst, 48V...

I too was thinking this may have been the fundamental problem- no power to the circuit. Ok, I'm sounding really, really stoopid here in front of an audience of experienced electrical circuit builders, but, now that I have identified the ignition wire- how do I "connect" it? ie I by a single pole...

Hi, Does anyone know the correct combination for an 18 FET sinewave controller from PowerVelocity connecting to a BMC 600T hub motor? I did the following, with no response: Controller / Motor For the phase wires- Yellow/ Yellow Blue / Blue Green / Green For the hall sensor wires- Yellow...