Recent content by tinasdude

"On a more positive note, after comparing my video from 2 days ago I would say it is getting quieter as it breaks in. Grinding noise seems to be less." What would concern me if the grinding noise is lessened, were those metal parts creating the grinding noise? Is there now metal dust or...

the BBSO2 is limited to how much offset a chainring can have. The 42 lekkie leaves only about 4-5mm before it would hit the motor. The eclipse does not fit the BBSO2. A chainring with slightly more offset would only gain about 1 tooth of improved chainline, but for many BBSO2 owners any...

Electron Cycles is working on the X1 with the ASI BAC 800. He seems to be very happy with it at 20S. Look forward to his final assessment in the near future. Lightning Rods has an adapter that can be used with 219 kart gears as primary. Should make experimenting with drive gears cheaper. He also...

important measurements for the chain drive. You should have a good idea of fit and make your plans with spacers if needed. https://www.facebook.com/photo.php?fbid=2473403469342531&set=p.2473403469342531&type=3&theater

Can the black and grey wire be accessed outside of the motor for the Domino throttle solution? If so where would be the best spot. sorry if this is a foolish question. i am electrically challenged, but follow instructions fairly well.

Was it determined if the controller is 60V nominal or 60V actual?

You changed out the JSTs on the Phaserunner to higo compatible with the BBSHD?. I was going to change the HD to JSTs, but Higo on the phaserunner would be much better. Where did you get your Higos? Could you share a parts list of what you you needed and used? Thanks

Christian, thanks for posting the links and the pics. Waiting in some IWISS JST crimpers and I will be taking the dive.

My motor is older and has no thermistor wire. what thermistor wire did you use and where on the stator did you install it. thanks

I have been reading about the BBSHD/phase runner combo. Some have gone with a 30T crank and another poster went with a 42T crank with a 42 rear sprocket. That is a huge difference in crank selection. Is that to get a higher top speed? What would be the advantages and/or disadvantages of each...

which iwiss crimpers for the jst's

Will this connector pack do the job? What would the best thermo paste to get? Again, thanks for your help here. You have given me the confidence or false confidence to move ahead...

Aerialpixels thankyou for sharing all your work with the phaserunner.

How much later in the year?

The CA3 with Higos is on his website.