This thread seems to have gone cold this year and there is not much happening on the Exess website, everything seems to be 2019- Does anyone have any updates on the company or the bikes?
I'm glad you stayed upright. I was just not expecting power wheelies to happen where to old setting started leveling off. I'm now typing with one handand not the right one.
Warning- use great caution when upping this parameter. 10 units at a time and then test- cover the back brake.
Also back...
Looking for someone with the Kelly kls7230s
I recently replaced my Adaptto Max E with a Kelly.
Everything works well on my Kelly controller system now except for what seem like a 45kph speed restriction. My controller seems to limit itself to 45kph on the road and 51kph on the bench with no...
Hi,
I have a 7P20S battery with 140 cells and 3 of 20 of the series are not charging fully- it is about 9 months old and only done say 30 cycles. I am using a Adaptto Max-E Controller and BMS.
17 the cells are very close to 4.16V. I have 3 that are low, 3.53, 3.7 and 3.8. these are on 3...
Thanks for that, will try these settings and see if that improves things. I am currently using lower (Dischg cutoff) 2.75x 20= 55 might knock this down a couple V, but I don't really want to kill the battery. Talking to my battery builder to see what he recommends.
I have been looking for...
Hello all,
Is there a good power mode profiles setup tutorial anywhere- or is is it trial and error? On boost I am now running IbA of about 135 and IpA of about 320- now getting some great acceleration, but I also get a low battery notice when the pack is down to about 70%. I am running an...
I am building a Qulbix 072r. I need some advice on electrical components and a question on battery.
I am going to be using the QS3 motor.
Qulbix now supplies Sabvoton SVMC072150 (72V 6kw) I am also looking at the Adaptto Max-E or mini-E controller as that seems to be the hot setup. Pros and...