Recent content by xlzeo

Hello . was trying to dig into searching but could not find any relevant information. i'm struggling to make a big 1KW hub motor run smooth with single 100V 120A UboX VESC. can anyone throw some advices or if you can refer me to a thread with the relevant information. my project details. 3...

hey there show a picture of the BMS. 7 wires for 7 connecction points. if you connect to main nagative terminal , and connect to main positive terminal and you have 5 more connections between cells (cell 1 connect's to cells 2, cell 2 connet's to cells 3 and so on..) then you have 5 wires. the...

thats not the case- , those forums are here to share everything, the good and the bad - i didn't wrote those threads to hurt him or anybody. i have spent so much money on hes store, and honestly i had bad expriance in the whole porcess, he gave me hard time on the purchase, on shipment and later...

hi guys,i just want to share with all of you a really important bad expiriance i am having with dexter from diyelectric skateboard. i have made couple of orders over the time , with total amount of over then 800$USD. i have purchase the welded motor mount kit becuase he advised to do so and used...

the link and page wont have more informaion then i already upload. on the original topic i upload the wiring daigram and instructions

yes if i set to locked when touching and moving it its start alarming , loud alarm is sounds i can hear from iys control box like witches opens or close when pressing the remote commands

no one of the pins gives 12V no voltage at all on any of the pins when turning on and off

yes i have tried wo look on the wiring diagram + check with multi meter to see witch wires are turn on when i disable and hit on (on the remote) but no wires gave me close shorts i have no idea how to wire

i have a bec for DC - DC . relay is not an issue , but hot to connect? do i connect to the ignition wires?

yes its working on 12V

hello i have infenioen 12 fets controller. i wish to connect this anti teft alarm so i will be able to start up the system with the Remote and turn off and activate the alarm with the remote but i have no idea how. attching the wiring diagram and instructions arrived with the alarm thanks in...

not working same problem

gosh you haven't answer my questions. i do not know what wires you are talking about. a picture will be helpfull. and an explanation. where those wires should be connect to ? i found the switch is solder on the BMS circuit of the battery pack.

what wires are those? may i see a picture? how to connect? those must be connect for ignite?

hello. i have boosted board dual motors. it seems like my battery is dead and id like to change it to new one. i have open the battery pack side , i have disconnected the -p / +p from the origirnal battery pack and tried to connect new one for test. in the test im using a li-ion 36V , fully...