Search results

Date Relevance Most replies

  1. N

    Rusted Turnigy 6364 213kv motor screws

    I have a dual motor mountainboard, one of the bearings was making a noise so when I decided to oil the bearing I found I can not remove the housing, the screws holding the housing are seized, has anyone had this issue with them? I would not have imagined that would even be a thing. What should...
  2. N

    Short battery duration

    Hello I have finally got my board going, I have a moutainboard with 2 X 6364 motors , Turnigy 200A Trackstar ESCs and 4X2s lipos 6000mah. I can run my board around for a bit until the batteries are flat but I could not go from town to town. IS there a way to get longer battery duration? I have...
  3. N

    Electric mountain board anti-spark plug/co burnt - advice ne

    Hello So I have been using my electric mountainboard for a couple of months, here is a video: https://www.youtube.com/watch?v=Z4Bapyc4Bsw&t=40s My setup is as follows. ESCs: https://hobbyking.com/en_us/turnigy-trackstar-1-5th-scale-sensorless-200amp-8s-opto-car-esc.html Bullet...
  4. N

    Blackened bullet connectors

    Finally got my 63/37 leaded solder from China and when heating up the bullet connectors to solder them the connectors have gone a bit blackened/darkened. :? Will this affect performance? Is the black flux? Is it lead? Thanks
  5. N

    Cutting one red cable dual ESC dual motor build

    Hi I am just getting bits together but have read in various plces that it is necessarry to cut one of the red wires on one of the escs to avoid it confusing the system. I am using 2X Turnigy 200amp trackstar and the red wire on both of them is already cut. Am I missing something? Thanks.
  6. N

    Choosing a battery for my board

    Hello, so I am getting everything together on my board. I have; Turnigy 6364 213kv motorsX2, Scramboard mounts+belt drive and MBS Atom board but no battery or esc. I am unsure of whoch battery/batteries to use, so far I have looked at these...
Back
Top