Search results

Date Relevance Most replies

  1. V

    SLCD-3 display settings, P and C parameters

    Hope someone still looking to that discussion here! Got a strange problem with a bike which I removed the burned controller and use a pair of KT kit. I successfully have the motor turning fine with C2 at 5 but only once. When I turn it off and back on again, the setting doesn't work anymore...
  2. V

    BionX hack: non-proprietary battery!

    I just have done it. I put the board bettween the bike and the new battery and the bike gets only 2 km from it. Once back on the charger, the battery charge for about 30 minutes max. The charger gets directly to the battery and doesn't go through the circuit board at all. Is the temperature...
  3. V

    NEW Portable E-bike Brushless Motor Controller Tester

    I replace one of the sensor since its legs were spliced in half.. but it seem that all the sensors are not getting enough voltage to work correctly. I put 5 volt between the ground and the + and I only got about 1v at the + sensor leg. The resistor in series with the input voltage seem to high...
  4. V

    NEW Portable E-bike Brushless Motor Controller Tester

    I got into a problem this week, a guy bring me a bike that doesn't work at all so I can fix it. When I test the motor with that tool, the main wires tested fine but nothing on the sensors. So I checked the motor's cable. The axle has spinned on the frame so, there I was, opened the wheel to fix...
Back
Top