Search results

Date Relevance Most replies

  1. I

    Cycle Analyst V3 preview and first beta release

    so, this might be a stupid question but i am a bit confused about the pas configuration possibilities with "stupid" magnet pas discs currently i am using a 12 pole pas device in basic mode with rpm downscaling, which works but i think this maybe can be improved. i stumbled across the pas mode...
  2. I

    Best geared hub motor for slow climbing

    MAC with 12T or 14T winding will nearly climb up a wall, see yourself -> motor simulator @ ebikes.ca
  3. I

    Cycle Analyst V3 preview and first beta release

    Hi! i just upgraded my CA to 3.11 and had some (new) strange things happening. After flashing the newest firmware it seems like the CA or at least the serial com interface crashed, i was not able to read/write anything from/to the ca. it always ended up in a timeout. sometimes writes where...
  4. I

    Anyone tried 12S LiFePo in Bosch Classic pedelec?

    I bet that the Bosch system will recognize too high voltage and lock the system with a error code.
  5. I

    Trouble balancing cell voltage with 13s BMS

    Get some tp4056 charger boards and charge each bank on its own. They can be found on eBay for 1-2€ pee piece
  6. I

    KT motor controllers -- Flexible OpenSource firmware for BMSBattery S/Kunteng KT motor controllers (0.25kW up to 5kW)

    is there any way to backup the original firmware?
  7. I

    MAC Hub Motor Noise Square Wave Infineon vS Sine Wave KT

    Hi! i am corrently using a 12T Mac Hub hooked up onto a 12 Fet EB312 Infineon Square Wave Controller which performs great except its noise. Especially during start the Hub makes a grumble noise until it reaches 5-6kmh. I dont think that this noise is generated by the planetary gears, correct me...
  8. I

    Cycle Analyst V3 preview and first beta release

    :( but yes, i understand your point. in one of the older firmware releases the CA showed a factor 1x 1.25x and so on, do you remember in which version this has been changed? maybe i am going to downgrade to that one
  9. I

    Cycle Analyst V3 preview and first beta release

    Heyho :) can i somehow hide the display output when using the analog poti + pas factor? i dont want the ca to display tons of watts while turning the pot, this could be very hard to explain in certain situations (EU 250w Limit). Cheers!
Back
Top