Search results

Date Relevance Most replies

  1. 8

    Odd controller cut out

    It works on 3 different voltage's 48V 60V 64V.
  2. 8

    Odd controller cut out

    Thank you, I did. Motor stays under 60c in 18c weather, even with the steep 7.5% grade road that I live on. Still double checked the connections. Joint's were cleaned then replaced with 60/40 and flux washed with 99% ISO. Do have silver solder on hand if need be. Left was factory right was me.
  3. 8

    Odd controller cut out

    Sorry, I do not know without a pedal assist sensor.
  4. 8

    Odd controller cut out

    After about 800km of use my voilamart controller (3 mode) has decided to randomly cut out. At any speed or incline it will cut out. Sometimes it happens right away, other times it take's quite a while before it appears. It will disappear just the same. Sometimes the power come's back if full...
  5. 8

    Is this controller programmable?

    So I soldered in cable's. GND ABS RST 5V TX RX Connected to USB to TTL 9600 baud 8 N 1 no parity Results on serial monitor where utter gibberish and one hex code. GND to GND 5V to 5V RX to TX TX to RX RST to ?? Reading online is to either push-button it to 5V or Gnd to allow uploading...
  6. 8

    Is this controller programmable?

    I see their is software out their for reprogramming controllers. Infineons, TSDZ2, BMS Battery's etc What about random clone controllers is their any compatibility? Chipset wise they all look similar these days. Can't seem to figure it out after hours of research.
Back
Top