Endless Sphere

Waste of a nice bike. Get a used steel frame and have two bikes. Under 100.00usd

I now know why I keep a junk pile. The more I do the bigger it needs to be. I would love to rummage through Dogmans garage. He knows the secret of melting motors or lifeforphysicks. Stored energy.

Just stretch it by hand or if you want to complicate it now go get a scissor car jack put it between the two dropouts and expand it that way.
Do put a torque arm on one or both sides.

I have a smoked muxus v1 3,000 the stator turned color for some reason ? Maybe I can just paint it.h But have magnets and ring for muxus 3,000 v1 and a 9c . And looking for more edge magnets or a ring from a melted motor . Good find on the varnish. I got the jb weld on sale 4.95usd have 2/3 left. I'...

Okay put it on the truing stand and I only had a just a couple smokes even changing 1 stator to a different hub. It's working I'm riding it now I have a 72 volt battery and a 50 amp BT controller I think 3,800 watts is too much I think I need to run it at 2800 or maybe 3000 Watts at the most. Commen...

Em3ev has a 13s charger with a 90% opion for more money.

I have had Two ebikes stolen I now go for the homeless look.

What are you trying to power ?.

Thanks Markz I not use enamel and see if it runs before forking over more money.. Test and then verify plus I being cheap for now.

Ok glued the magnets in I have Rust-Oleum clear enamel. Can I use it for a coating on the magnets ?.

? What charger doyou have ??

Ok glued the magnets in the sun rim it has brass washers under the spoke heads with JB weld 550 temp. Quarter it out with 4 different color markers. And the last one fit (magnet). One magnet was broken and two I broke. Lucky I had extra magnets from first wheel. But not enough for two. I now have tw...

Well yes there is more inside that case a bms with 15 wires first one is neg one the second is pos one .now move pins over so now #2 is now neg #2. And wire 3 is pos #2 and so on to wire #15 kis pos # 14 . do some reading and some advice from fechter.

As a rule do you run the battery down to a cuts out yes no

The bms should drain the high cell(s) then charger turns back on and try to fill up the low cells. Then when high cells bleed down charger should return on. If not you can unhook charger and let bms drain cells after 3-4 hours plug back in. What battery do you have a link ? All batteries are made di...

It may be a low parallel set of cells or more. Do you run battery to cut off lvc ? You can check the state of charge by finding out each group of parallel cells voltage and write down on paper like this.
1. 3.85v
2. 3.99v
3. 4.00v


14. Xxx volt
Plus check voltage of charger ???
Write it down

Buy some of those LTO for 12v 6 of them or high quality lifepo4 and forget about it. Ohhave some sense wiresto monitor so don't forget get about it. Quality cells need little maintenance But you should know what's end is up. Use your ebike batteries for carrying you UP. Or for the end of the world. ...

I think it was shitty gule. Oh and a little heat. I found jb weld 550 temp so that should not have a problem. I made a pie the inside of the hub and folded it twrice to make 4 quarters then with marker made squgily lines so not to mix up magnets. And light magnet is best to find poles just in case.

Motor ? How much money you got ? 700.00usd battery and a middrive many different prices and quality and battery too get one with throttle. Em3ev makes good batteries. Custom if needed maybe small custom double wide 18650 you bow-legged lover. Your knees will never touch again. Imean even I can swim ...

Had one thunderpower 1220 it went south so returned it and brought a new one so have two both can't boot them up they try. They start then go South

New spoke question. I had to does these toaddto title.

Looking at my lace job and on the weimann. The first spoke crosses under and looking at the sunrim the first spoke crosses over ? Is there a right and wrong wayforspokes to rotate ?

Ok ah is like a 5gal bucket or a 10 gal bucket or 30 gal bucket so it's capacity or amount. Amps is how big the hose is like a garden hose or fire hose or volume of use. Volts is the pressure . I hope that's right ? Maybe someone can help me with volts haha. Check the voltage of your charger and a l...

I brought 38 spaim 13/14 spokes and nipples 60.00usd shipped.

A meanwell is great but will not shut off and if you put a timer on it it will still drain thru the charger. A 5a kingpan is what you need most of the metal case ones have a tirm pot. But can tell you which ones. Ping did sale them. Your bms is rated for charging rate which is ?