Search found 13 matches

by cs70
May 11 2012 12:20pm
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

Finding the PAS connector is easy. Look for the sensor which is fixed on the bottom bracket next to the magnet ring. Follow the wires into the compartment and pull them a bit from the outside to see which ones move on the inside. I don't quite agree with Dogman on the shunt soldering. As long as yo...
by cs70
May 11 2012 11:51am
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

It's possible that it's 2 wires coming out to a plug that has a loop back connector on it. It's also possible that they strapped it internally on the controller board so it couldn't be changed without pulling the controller cover off. hey man thx yeah its possible i will open the controller and che...
by cs70
May 11 2012 10:03am
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

it is not illegal to remove it, it is illegal to ride it on the street in europe or ozzieland with the limiter removed, so you use the term 'off street' travel. i think it is just limited by the shunt current limit of 7A. maybe someone has an idea of how to defeat it and the pedal assist sensor too...
by cs70
May 11 2012 9:48am
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

the guy in the shop tell me its illegal to remove speed limiter hahahhhahahaahaha he told me if i buy new controller than i can program it how i want
put tape around the wire without cover
best regards
by cs70
May 11 2012 9:45am
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

ok so the 2 black wires with pin are gays hhahahah they dont connect to each-other
there is one yellow wire not plugged in
no the wire not get hot or warm when battery inserted
stupid shit cant find wiring diagram for this controller
best regards
by cs70
May 11 2012 9:35am
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

there is wire that looks brown that has no plastic plug on it to cover the exposed pin. check to see if that wire is hot when the battery is attached, i know you can't now but you should not have exposed conductors. there are two black wires on the lower left in the last photo with plugs on the end...
by cs70
May 11 2012 9:27am
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

i actually dont want no option for the bike no pedal assist nothing only start the motor and ride not all this shit that comes with it
best regards
by cs70
May 11 2012 9:20am
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

hey guys so here is the situation
i dont see any single wires connected to single wire and go back to controller
the grey wire is connected together with black wire to many wires
here few more pics of the wires
i try to contact the manufacturer but no response yet
thx best regards
by cs70
May 11 2012 8:50am
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

thx for help
i will check now the one wire that connect to single wire and go back to controller
thx
by cs70
May 11 2012 5:51am
Forum: E-Bike General Discussion
Topic: Full-throttle controller short?
Replies: 7
Views: 7735

Re: Full-throttle controller short?

HE MAN
pleasei bought similar folder bike with same configuration
how u disconect PAS pedal assist?
best reg
by cs70
May 11 2012 3:56am
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

hi so here is th pics of the controller ,its quiet small like cigarettes pack ,so yeah kind of a jungle wit all cables lol so what should i disconnect? also each time i push the breaks, brake lights in the back is on ,its sucking my energie from battery i dont want break lights tell me please what s...
by cs70
May 09 2012 4:13pm
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

Re: hi fellow riders please some help needed

thx ppl for ur help and advice,the controller is located under the batery i will open it and make picture which wire i have to cut
also can i just cut the halo sensors wires?and also lamp each time i brake lamp in the back is on ,can i cut the wires that lead to lamp?
best regards
by cs70
May 09 2012 12:51pm
Forum: E-Bike Technical
Topic: hi fellow riders please some help needed
Replies: 23
Views: 1275

hi fellow riders please some help needed

hi guys sorry maybe i posted in wrong section,so i bought only ebike available here and wanted to know if i can do anything to improve the performance a bit i ride with my 6 years old daughter its 250 W 8FUN brush less motor with sensors for pedal assist and speed limiter the controler is under the ...