Search found 6 matches
- Aug 17 2017 7:07pm
- Forum: Electric Watercraft
- Topic: Electric Hydrofoil/E-Foil
- Replies: 463
- Views: 71113
Re: Electric Hydrofoil/E-Foil
The epoxy was used as a thin barrier coat to seal the pla parts prior to assembly. However the end pieces were epoxied into the aluminum tubing so it would not be easy to disassemble. The rear cone with the shaft seal is screwed to the main body with an o ring sealing this area. I can access the rea...
- Aug 17 2017 12:40pm
- Forum: Electric Watercraft
- Topic: Electric Hydrofoil/E-Foil
- Replies: 463
- Views: 71113
Re: Electric Hydrofoil/E-Foil
Printed with pla, infill varied slightly but most parts were printed at 70 percent. Sealed with epoxy resin. O rings and marine 5200 used between sections.
- Aug 17 2017 7:42am
- Forum: Electric Watercraft
- Topic: Electric Hydrofoil/E-Foil
- Replies: 463
- Views: 71113
Re: Electric Hydrofoil/E-Foil
More pictures
- Aug 17 2017 7:36am
- Forum: Electric Watercraft
- Topic: Electric Hydrofoil/E-Foil
- Replies: 463
- Views: 71113
Re: Electric Hydrofoil/E-Foil
Here is my setup, similar to the other ones that have been successful. Thanks to all of the previous designers for the information to make a successful efoil! Custom diy foil, wood core with carbon fiber lamination, foil lifts at 4 mph Parker PV17FE-010, 10:1 gear ratio SSS 56104 500KV 6 pole brushl...
- Aug 16 2017 8:53pm
- Forum: Electric Watercraft
- Topic: Electric Hydrofoil/E-Foil
- Replies: 463
- Views: 71113
Re: Electric Hydrofoil/E-Foil
Success on first water test today. Was using 12s. I will post details on my setup tomorrow.
https://www.instagram.com/p/BX4GjLKA_Nv/
https://www.instagram.com/p/BX4GjLKA_Nv/
- Jul 20 2017 8:14am
- Forum: Electric Watercraft
- Topic: Electric Hydrofoil/E-Foil
- Replies: 463
- Views: 71113
Re: Electric Hydrofoil/E-Foil
Trying to figure out what kind of input gear or ring gear is required to use the torqeedo gear reduction. Has anyone seen the input side yet?