Endless Sphere

Hello group, I have a dead votol em150sp controller Can not respond to the pc program please someone if anyone has the bin file of the Votol em150sp Can from Siaecosys send it to me by miguelangel891123@gmail.com thanks.

Unfortunately I still have no idea how to use the values I gathered from the calibration in Page 2. Due to I am afraid to demagnetize the magnets, I don't have the guts to ride the bike until this is set up correct. However, I used the time waiting for help for a small improvement: My old controlle...

Turn the motor by hand, if it turns as locked, it means that some mosfets to the controller were burst, it happened to me with a votol em150s controller I had to replace 4 mosfets

I don't know if that's your problem, but if it was mine, in any case check the motor connections, they may be poorly connected. Previously it worked fine, did you change any settings?

Hello, the same problem was happening to me and it turns out that it was a problem in the motor sensors that were a little outside the magnets
Is your motor hub or mid? mine is hub.

I already tried another 72v 1000w and it sounds ugly the same

Hello group, sorry for the intervention, is that I bought a votol em150s controller and installed it to a Yumamotor 72v 2000w 28-pole hub motor, the problem is that at low rpm it works well but at high rpm it starts to sound ugly and disconnects itself and it is activated in fault display motor hall...

Hello group, sorry for the intervention, is that I bought a votol em150s controller and installed it to a Yumamotor 72v 2000w 28-pole hub motor, the problem is that at low rpm it works well but at high rpm it starts to sound ugly and disconnects itself and it is activated in fault display motor hall...

Hi, what is the difference between the CAN controller and normal controller.

alek.palmero wrote: ↑

Jan 23 2020 9:19am

Thanks!
How do you know it?
In the PCB I didn't see any label indicating which one is every wire.

Thanks again!

Enviado desde mi Redmi Note 7 mediante Tapatalk

In the design manual it is a low brake but in the program it appears as side sustaind

Listen Miguel, the cruise control does actually work. I just changed pb3 input to 15:cruise and activated it with my sport mode switch without any surprises. However it's kinda shaky @ no load. It's deactivated on a throttle move or the switch. Just find an empty input and make use of it. Here's ho...

My motor is 72v 1500w, I have the sport cable deactivated, why does it do that to me at high speed? How can I send you a video?

My problem is that although I change the high speed values ​​from 60% to 99% it works equal to 550rpm but when I release the accelerator and return fast it reaches 720rpm and the regen starts to flash and slows down in armholes

It's my first time using a votol em150s controller, I want it to work well on my 1500w 56 magnet hub motor, and how do I activate the cruise?

Hi group, I bought a votol em150s driver from qsmotor but it doesn't work well for me. My motor is 1500w. 1- the software does not recognize it as em150 but as em100 2- the engine works well at low rpm but not at high rpm 3- how the crusero mode is activated. Thanks, any comments would be very helpf...